...
community_w – is a password that corresponds to an SNMP community for write. It is indicate indicated at the page «SETUP» of a device web interface. It is possible to use Latin letters, numbers, character «_» without quotes and spaces.
...
Command Code | Description | ||
---|---|---|---|
Pn+ | Switch on a relay n, where n is a relay number | ||
Pn- | Switch off a relay n, where n is a relay number | ||
PnR | Reload a relay n, where n is a relay number
| ||
PnW | Switch a relay n into the management mode «Watchdog», where n - is a relay number | ||
PnS | Switch a relay n into the management mode «Schedule», where n - is a relay number | ||
PnX | Switch a relay n into the management mode «Schedule+Watchdog», where n - is a relay number (in the process of development) | ||
PnL | Switch a relay n into the management mode «Logic», where n - is a relay number | ||
Pn? | Request a status of a relay n, where n - is a relay number | ||
P? | Request a status of all relays in a brief form | ||
N? | Request a status of a pinger | ||
Tb? | Request readings of a temperature sensor b, where b - is a number of a temperature sensor | ||
Hx? | Request readings of a humidity sensor x, where x - is a number of a humidity sensor | ||
A? | Request a status of a battery |
...
kkkkk –is a request identifier (a random number). It is repeated in a response for setting a correspondence between a request and a response. It is an optional element of a command. If there is no identifier in a command, there is no identifier in a response
An incorrect passsword password (Community) in an outgoing command:
...
b – is a number of a temperature sensor
t – is a current reading of a temperature value, in °C
t1, t2 – are thresholds of a «normal range» of a temperature, in °C
kkkkk – is a request identifier (a random number). It is repeated in a response for setting a correspondence between a request and a response. It is an optional element of a command. If there is no identifier in a command, there is no identifier in a response
...
Info | ||
---|---|---|
| ||
NP REPLY Hx=h% BELOW SAFE RANGE (h1..h2%) T= tC kkkkk NP REPLY Hx=h% IN SAFE RANGE (h1..h2%) T= tC kkkkk NP REPLY Hx=h% ABOVE SAFE RANGE (h1..h2%) T= tC kkkkk |
where:
h – is a current reading value of a relative humidity, in %
h1, h2 – are thresholds of a «normal range» of a relative humidity, in %
t – is a current readings of a temperature value, in °C
kkkkk – is a request identifier (a random number). It is repeated in a response for setting a correspondence between a request and a response. It is an optional element of a command. If there is no identifier in a command, there is no identifier in a response
...
V – is a power supply source, and can have the values: «220V» (220V grid power), «BATTERY» (battery power)
С – is a battery status, and can have the values: «OK» (battery is full), «LOW» (battery is low)
...