[SMS] Sockets and Indication Elements
Sockets and indication elements on a front panel of a device are shown on the picture:
Sockets and indication elements on a back panel of a device are shown on the picture:
Reset Button
Reset button is designed for resetting parameters to factory values. To reset parameters press a Reset button with a keen object and hold it during a device turning on.
SIM Slot
A SIM Card slot is designed to install a SIM card. A SIM card is installed contacts down. A truncated edge of a SIM card should be inside a device. Correct installation of a SIM card is shown on the picture.
GSM OK LED
When lighting, it means a successful connection to a GSM network and readiness to receive/send SMS messages.
GSM ANT Socket
A GSM ANT socket is designed for connecting an external GSM antenna to a device.
LAN Socket
An Ethernet 10/100 BASE-T port is used for connecting to a network.
An Ethernet port has two LEDs. The left one – CPU, when lighting, it means a device is turned on and when blinking it means transferring packages to a network. The right one – Link, when lighting it means having a link on the port, and when blinking, it means receiving packages from a network.
EXT BAT STATUS Terminal Block
The functionality of this terminal block is not implemented in the firmware of the device, so in practice it cannot yet be used.
A EXT BAT STATUS terminal block is designed to connect IO STATE lines of a NetPing mini-UPS device.
Terminal 1 –. GND
Terminal 2 – IO Line 2
Terminal 3 – IO Line 1
Logic level 0 – no more than 0.3 V. Logic level 1 – no more than 0.7 V. A maximum allowable voltage is 5 V.
Electric parameters of IO lines
In the «output» mode:
- the voltage of logic «1»: maintains +3,3V 2mA (is not used as the output);
- the voltage of logic «0»: maintains 0 V, 2 mA (is not used as the output).
In the «input» mode:
- voltage of logic «1»: > 2,31 V;
- voltage of logic «0»: < 0,99 V.
Equivalent Circuit
+12V Socket
+12V socket is designed to connect an external power supply unit. A power supply socket polarity: “+” in the center.