[ENG] 9.2. [DKSF 70/71.5 IU] Initial Configuration of 1-Wire Smoke Sensors

Owned by Olga Talanova (Unlicensed)
Last updated: Nov 25, 2015
1 min read

At the page «1W SMOKE SENSORS» of a device web interface, a status of smoke sensors that are connected to a device is displayed. It is possible to plug up to four smoke sensors of a 1-Wire model line to a device.

To plug in a sensor, indicate its unique number in the field «Unique If of 1W Sensor».

Unique If of 1W Sensor – is a unique number of a 1-Wire smoke sensor, connected to a 1W socket. The address consists of 4 four-digit numbers in hexadecimal notation. On default: empty line

A unique Id of 1-Wire sensor can be found in two ways:

  1. A unique Id of a 1-Wire smoke sensor can be indicated at the sticker on the sensor itself;
  2. A unique Id of a 1-Wire smoke sensor can be found after reading the section «9.1. [DKSF 70/71.5 IU] How to Determine a Unique Id of a 1-Wire Smoke Sensor?»