[ENG] 3.6. [DKSF 54.3 IU] There Is a Need to Send SNMP Trap Notifications. How to Configure This?

IP addresses for sending SNMP TRAP notifications are configured is on the page  «SETUP» of a device web interface. This group of settings allows to set up to two addresses where SNMP TRAP notifications will be sent using an SNMP protocol. The events about which these notifications will be sent are specified on other pages of a device web interface.

In the section «SNMP TRAP», it is possible to configure:

SNMP Trap Destination #1 – is a field for setting or changing the first address where SNMP TRAP notifications will be sent. It is acceptable to specify an IP адреса or a domain name. An empty field means that SNMP TRAP notifications will not be sent. On default: address is not specified.

SNMP Trap Destination #2 – is a field for setting or changing the second address where SNMP TRAP notifications will be sent. It is acceptable to specify an IP address or a domain name. An empty field means that SNMP TRAP notifications will not be sent. On default: address is not specified.

Periodic Sending of Traps – enables periodic sending of SNMP TRAP notifications is temperature and humidity sensors connected to a device for a long time, do not return to the status «in a range». Repeated notifications contain time for the first alarm to appear in the format DD.MM HH:MM. Possible values are: «off», «5 mins», «10 mins», «15 mins», «30 mins», «1 h», «2 h», «4 h». On default: off.

After setting all necessary parameters, click the button «Apply changes».