...
Rules of «While» type always have a higher priority regarding in relation to the rules of «If» type, regardless their mutual location in the list.
...
Value | Description |
|---|---|
RESET | Signal, which is active 5 seconds after starting the module «Logic» or rebooting the module «Logic» by the button «Reset» at the web page. it It is used for a primary hardware initiation. For example, it is possible to program a 5-second pulse for a relay at a logic start or issue and IR command to switch a device off. |
IO 1 | IO line 1. Before using it must be switched to the mode «input» at the page «DISCRETE I/O» |
IO 2 | IO line 2. Before using it must be switched to the mode «input» at the page «DISCRETE I/O» |
IO 3 | IO line 3. Before using it must be switched to the mode «input» at the page «DISCRETE I/O» |
IO 4 | IO line 4. Before using it must be switched to the mode «input» at the page «DISCRETE I/O» |
TSTAT 1 | Thermostat 1. A thermostat must be configured at the page «LOGIC» before using |
TSTAT 2 | Thermostat 2. A thermostat must be configured at the page «LOGIC» before using |
PINGER 1 | Pinger 1. A pinger must be configured at the page «LOGIC» before using |
PINGER 2 | Pinger 2. A pinger must be configured at the page «LOGIC» before using |
C.S. ALARM | An alert signal of a smoke sensor (current sensor). The signal «C.S.ALARM» works when parameters of a sensor leave configured conditions «Alert» at the page «SMOKE» of a device web interface |
C.S. FAIL | A signal of smoke sensor (current sensor) failure. The signal «C.S. FAIL» works when parameters of a sensor leave configured conditions «Loop Breakage» and «Loop Short Ciscuit» at the page «SMOKE» if a device web interface |
| C.S. NORM | A signal of a normal operation of a smoke sensor (current sensor). The signal «C.S. NORM» works when parameters of a sensor satisfy configured conditions «Alert», «Loop Breakage», «Loop Short Circuit» at the page «SMOKE» of a device web interface |
| AC PWR | Availability of 220 V power at an input of a device |
5. Condition
A condition within which a rule is applied and a command is issued, which changes a status of an output. An available set of conditions is changed depending on a chosen type of a task. Conditions represent a sense of an input status. Possible values for a pinger are «Silent», «Reponds». For an IO line, possible values are «logic 1», «logic 0». For a thermostat, possible values are «Below Specified Т», «Above Specified Т».
A rule of «If» type works only in the moment of satisfying a condition.
A rule of «While» type works all the time while a condition is satisfied.
...
For a rule «While» possible values are – «Keep switched on», «Keep switched off». These commands work all the time, when time when a condition is satisfied.
...
Buttons «Start» and «Stop» control starting and stopping of rules operationsoperation. This state is kept when a device is switched off. If rules are stopped, a warning line of a logic status «10» appears.
A button «Reset» switches the outputs, which are controlled by a logic module, into a specified initial status and initiates a reset signal. Rules, which have a reset signal RESET as an input, can switch the outputs into a necessary required initial status. There is a need to note that if rules are not stopped before clicking the button «Reset», a status of outputs can be immediately changedand changed and a reset command will not have any external effect.
...