[ENG] [886A02] Installation and Connection

The converter can be mounted on a horizontal or vertical surface. There are mounting holes.

When you install the converter pay attention to the next restrictions:

• Do not expose the converter to direct sunlight.

• Do not install the converter near heat sources.

• Do not open the converter case.

• Avoid getting liquid on the converter particularly on the connectors.

The sequence of connection:

Step 1.

Remove the converter 886A02 from its packaging. Put it onto the place you need.

Step 2.

Connect the converter to the 1-wire port of the device (or through an extension-splitter) to which you are connecting it. The host device must be disconnected at the time of connection, otherwise it can be rebooted.

Open

Step 3.

Connect the sensor to the converter.

Open

The configuration of the sensor and notifications you can see in a description of a built-in firmware on a connected host device.