[ENG] 10.6. [DKSF 54.2 IU] Reset Signal and Initial Statuses of Outputs

At the start of the firmware operation or when clicking the button «Reset» at the page «LOGIC» of a device web interface, outputs are configured, which are configured by the logic, into the certain initial status. On default, this status is «off», or «logic 0». Another status can be set with the rule at the page «LOGIC», which uses a reset signal «RESET» at the input.

After restarting the firmware, saving logic settings or after clicking the button «Reset» at the page «LOGIC» a 5-second pause is maintained, then a reset signal «RESET» is activated in 5 seconds.

A rule with a condition «If RESET = logic 1» works 5 seconds after a reset moment.
A rule with a condition «If RESET = logic 0» works 10 seconds after a reset moment.
A rule with a condition «While RESET = logic 1» is active 5 seconds after a pause during 5 seconds.
A rule with a condition «While RESET = logic 0» is always active except for 5 seconds of a reset period.

Thus, it is possible to form a five-second external reset pulse at one or several outputs or provide a correct sequence of a power supply to external devices.