[ENG] 3.4. [DKSF 54.3 IU] How to Set Community for SNMP?

Owned by Olga Talanova (Unlicensed)
Last updated: Jun 11, 2018 by Sergey Eremeev (Unlicensed)
1 min read

To configure Community, there is a need to go to the web page «Setup» of a device web interface:

In the section «Access Restrictions» it is possible to configure:

Community for Read – is a field for setting up or changing Community for read parameters of a device when accessing a device via an SNMP protocol. Its maximum size is 16 characters. On default: SWITCH               

Community for Write – is a field for setting up or changing Community for write parameters of a device when accessing a device via an SNMP protocol. Its maximum size is 16 characters. On default: SWITCH

After setting up all necessary parameters, click the button «Apply changes».